Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Tell Tale Gauge Typical Installation
Does anyone have some specific guidelines or rules of thumb for installtion of a tell tale gauge between a Rupture Disk and PSV? I am aware that they are required by code. I am also aware that each of the rupture disk manufacturers will try to sell you their own version of a Tell-Tale...- ms323
- Thread
- Replies: 6
- Forum: Safety Relief Valve engineering (PSV)
-
Freezing Temps in a Heat Exchanger
ornerynorsk - thanks for the quick response! Agreed that a centrifugal separator is a far more efficient way of removing water... however, removing the water is not 'necessary' for the process. Unless, removing water (prior to freezing) is the only way to effectively chill the stream, and...- ms323
- Post #3
- Forum: Chemical process engineering
-
Freezing Temps in a Heat Exchanger
Greetings, all. I have a hydrocarbon stream which contains no more than 2% Water, (often much less, but there is always SOME water). For a variety of reasons, it is desired to cool this stream to around 20 degrees F. However, this will (obviously) cause freezing of water, and very likely the...- ms323
- Thread
- Replies: 3
- Forum: Chemical process engineering
