Topological transformations, huh? Do you know where I can get a nut with a fractal thread profile, so that there will be infinite surface area to wear away? Really, no such luck though. The actuator assembly is already in a J configuration, the pulley on the lead screw has been substantially...
Hello everyone and thank you for your interest. I had fires to put out today and am just now getting back to this.
I'll address issues in the order they were raised:
Pud: The paper you linked has some great general info, especially related to material selection, but I don't have the knowledge...
I have a lead screw application where a mechanism needs to be sealed up and run for long periods of time. Currently, we are using a brass nut on a stainless steel lead screw. Because of space constraints, the length of the nut is very short: 0.2 inches (4 threads on our 1/4-20 lead screw). We...
I've done this very thing before using software called Teamviewer. It's free to try and has yielded OK results, and even has apps for controlling your computer from your smartphone (not that useful, IMO). You can do things like reducing the color depth and resolution of the remote computer to...
Also, think about how flatness and surface finish are measured. You could measure flatness by dragging the part around under a dial indicator, and have the face seem perfectly flat, because the large surface area of the indicator spanned the small irregularities. But, that surface could have...
Thanks for the link, ione.
That really is a pretty exhaustive paper! I couldn't find exactly what I was looking for in there, but it should certainly get me within an order of magnitude.
Hey folks,
I am trying to find some numbers for thermal contact conductance (or resistance, or course) between two copper parts with a pressure between them around 20 kPa, with and without vacuum grease. I have googled all over and looked at a lot of scholarly articles(they were all a little...
Another option would be a rotary damper. These things offer a resistance that is proportional to rotational rate, so at some speed everything would balance out.
http://www.mcmaster.com/#rotary-dampers/=ex7piy