Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: rguil
  • Order by date
  1. rguil

    Clearance

    Does anyone have experience with reducing compressor blade to case clearances using abraidable coatings, ie... Aluminum, Honeycomb...? I am looking for the effects of different clearances on compressor performance or possible surge due to excessive turbulence caused a negative clearance. I am...
  2. rguil

    Compressed Air

    If I direct compressed air to the inlet of a compressor, would I expect a benefit because of a higher inlet presssure or would it be at ambient pressure since it is released? I beleive I am asking the correct forum?
  3. rguil

    Bronze bearings

    Does anyone have any experience repairing damaged gear pump journals, which ride on bronze sleeve bushings?
  4. rguil

    17-4PH

    I would like to join two cylinders via EB weld and would rather not do a PWHT, other than possible a simple stress releive. The parent material is 17-4 in the H1100 condition. Does anyone have any thoughts on this procedure or data to on the mechanical properties?
  5. rguil

    Interference fit analysis question.

    I would treat the problem with the assumption that the outer component will not yield.
  6. rguil

    oversize hole repair

    What is your parent material? Would a weld build-up help? I recently had the same problem and I performed a build up on a Mg casting. Approval and substantiation was not a problem since this is not a new technique and it is used extensively during manufacturing. Before you begin such a...
  7. rguil

    Aircraft Systems Websites

    I think aerolearn.com can help.
Back
Top