Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. tuanjim

    Economic transfer of acidic flue gas

    Hi, I am a process/chemical engineer with very little experience in moving gases and am hoping that some of the experts out there might be able to help me out with what I see as a fairly tough design problem. The process I am involved with requires that we transport flue gas from an exhaust...
  2. tuanjim

    Calculating cost of gas compression

    Hi, Does anyone out there have a rule of thumb that they would use for estimating the costs associated with compressing and moving a gas? I want to inject CO2 into a liquid stream at a depth of 6ft through a sparger. I would assume that it would be somewhat compressor and flowrate specific but...
  3. tuanjim

    Dewatering algae

    Thanks guys. Kenvlach - we would be looking at processing close to 34 MGD..Is it possible that a filter press system could handle those loads economically could the low permeability of the algae once a cake has formed?
  4. tuanjim

    Dewatering algae

    HI, I'm involved in the early R&D stages of identifying the best available technology for dewatering algae and am wondering whether anyone out there has had experience in this field at all and would be able to offer up useful advice? Following initial screening tests with various coagulants and...
  5. tuanjim

    Vessel Code?

    Thanks very much everyone
  6. tuanjim

    Vessel Code?

    Hi, I'm a junior engineer so I apologise if this is an obvious question but I am wondering if anyone out there could help clear up an issue I'm having with defining what exactly is considered a pressure vessel - or more to the point, at which stage does a pipe etc. become a vessel? My basic...
  7. tuanjim

    Sample point off 2" Sched 80 pipe

    Hi, I hope this isn't too stupid a question but I'm not much of a piping specialist! I need to sample off a 2" schedule 80 pipeline which may or may not be fully-flooded. This pilotng facility is yet to be built and I can pretty much dictate the sample point design. My initial thoughts were to...

Part and Inventory Search

Back
Top