Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. FOSSIE

    Drawing an involute spline

    DIAMONDJIM - can you just go through that trick with the pins in a bit more detail please... I think what your trying to say is place 2 pins against the bottom land of the external spline, and from this i can calculate the major diameter for the internal spline? is that right?
  2. FOSSIE

    Drawing an involute spline

    Thanks for all the help guys! I'm new to this game, but learning as we go along. I'll do some homework and find the other parameters you mentioned gearguru. I'm not sure about the "side fit" or "OD" fit - but the splines engage without needing any force. Instinct tells me...
  3. FOSSIE

    Drawing an involute spline

    Hi, i need a 2D drawing of an involute spline in order for me to be able to cut the internal spline using wire EDM... I understand there is software available that can help with such a task? The spline in question is: no. of teeth = 18 P.C.D = 1.125" D.P = 16/32/80 P.A = 30 degrees I...
  4. FOSSIE

    Driveshaft/planet gear splines.

    Hi there, im new to this forum so please be patient with me! I am looking for some advice regarding driveshafts/splines from an ATLAS axle. This is the rear "live" type axle, I don't know how familiar you will be with these, they were standard in Ford capri's, transit vans etc etc over...

Part and Inventory Search

Back
Top