Search results for query: *

I'm try to conduct destructible tests on a piece joined by adhesive. i have adhesive's mechanical properties. I am in a bit doubt about how to model adhesive in abaqus, should i model it as a part and assign it material with those properties or should i go for fluid contact as when the adhesive...

i've to assign ultimate tensile strength for adhesive modelling along with %elongation in break i cant find it in mechanical category of abaqus!!

Finite sliding or small sliding are a part of surface to surface contact only , i have defined general contact for *all in analysis step

I'm trying to conduct an analysis in which a rigid body inclines and falls on a deformable body... while doing so i observe that deformable body is getting stress before coming in contact to rigid falling body and the members are stressed without any contact. what can be done to prevent it...

i'm trying to simulate a rollover of a rigid body with point/structural mass inertia in order to analyze the barrier on which it will be falling for impact analysis. For this i've created a 3d deformable plate acting as ground and thereby converting it into rigid body via rigid body constraint...

i'm trying to tilt a rigid body with point structural mass by tilting a rigid platform acting as ground , the whole body is under gravity, i have to analyze the counter bars standing on the tilt test platform, while trying following error was shown. "Rotary inertia for the rigid bodies with the...