Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. joebems

    Capcitor case size

    Thanks
  2. joebems

    Capcitor case size

    So given the same Mfg, same materials, bigger is better?
  3. joebems

    Capcitor case size

    What is the difference between motor start capacitors with the same voltage and mfd rating but different case size?
  4. joebems

    Motor Run Capacitors

    What are the consequences of replacing a 370 volt motor run capacitor with a 440 volt, same microfarad?
  5. joebems

    Winding Data

    I am looking for the winding data for a 15 HP Myers Submersible Pump Stator, Model # 4RH150M2-23, 3450 RPM, 3 Phase, 230 Volts, 32.5 Amps. Core measurements are: Length = 5", Diameter = 7.5", Back Iron = 1.02", Tooth width = 0.157", slots = 36, Bore Diameter = 4". The data I have is: 2 wye...
  6. joebems

    condensation

    The cord is about 100 feet long. But there is a small amount of water inside the connector. Thanks for info.
  7. joebems

    condensation

    I have a pond aerator with a submersible connector sealed at both ends and a clamp/o-ring seal around the middle. All seals seem fine but the GFI will soon kick out. I assume this is due to condensation in the connector compartment. There is a small amount of water present. How do I solve...
  8. joebems

    Two speed motor winding

    I have a 15 HP, 1800/1200 RPM motor. It needs rewinding. I never use the 1200 RPM speed. My question is: Can it be rewound for just the one speed 1800 RPM? Thanks, joebems

Part and Inventory Search

Back
Top