Thanks rcfanatic
I think you're pointing me to the mesh nodes, what I'm looking for are the Nodes od the Mode, ie the points of minimum (=0 in theory) displacement for a specific mode
Hi,
I ran into the same problem with these spec, but on the other side of the fence.
It seems to me that in order to facilitate the HT supplier they are requiring the EQUIPMENT to conform to AMS-H-6875, as the other ones have much stricter requirements.
In other specs I found 80F.
All in all...
Thanks for the suggestions!
The general problem is that for manufactugin purposes i can't tighten any tolerance.
The mating part is similar to a part with 2 pins that mate with each hole 10+/-2 aside. Then i need the mating part to be in an area 40+/-5 in length.
In reality the problem is...
That's what the mating feature allows +/-2 for the hole and +/-5 for the overall length. For manufactugin purposes I can't tighten the +/-2 to match the +/-5 overall tolerance
Hi all,
i have a tolerancing problem similar to this example:
a. 5 holes on a flat surface, along a line;
b. the distance between each hole should be 10 +/- 2
c. the distance between the fisrt and the last hole should be 40 +/- 5
With dimensional tolerancing only the 2 tolerances don't stack up...