Search results for query: *

Just thought I'd update this for anyone who was interested. We pulled the remaining three motors and had them sent to a factory-owned repair center. They tore them apart (found no water), replaced two of the motors and rebuilt the third. I haven't been able to get a report from them detailing...

We recently installed a scissor lift table on one of our custom furnaces to act as the door mechanism. The total load on the lift table is 2500# and our customer requires that it descend in less than five seconds. At this rate, we are noticing a shuddering when it first begins to drop. The...

ElectricPete, We are providing trickle voltage on the windings of the motor when it is not running. We only ran these for a short period of time in the field. Have you seen this much water caused by condensation alone? Thanks, Dave676

We recently purchased (4) direct drive blowers for installation on skids that we then shipped to a customer in New Jersey. We ran some brief run tests in our shop to verify that each blower functioned. The original submittal from the blower rep included Baldor motors, but upon receipt of the...