Hi,
Is there way to try a trial version of Cosmos Floworks? It's awefully expensive to buy a $8000 or so software?
It's really tempting to pay $75 for a pirate version but don't know what to do.
Hello,
I am planning on doing some dyno test and would like to have fuel flow or rate sensor.
Who sells an inexpensive sensor that's adequate for this kind of job?
wsjoe
Thank you andyv8 for your recommendation.
Which pressure transmitter have you used? I want to collect data and pick them up from a computer. I guess I can use Labview for data acquisition, but this is kind of expensive. Have you seen cheaper alternatives?
Know anything about pitot tubes...
What type of sensor is best suited to measure pressure in the exhaust (muffler) at high temperatures of the exhaust (around 1000F)? I want to measure the pressure at different points of the exhaust and see how they change as engine rpm varies. Which sensor do you recommend? What is the range...
Thank you for your inputs!
How do you sweep CUT? I know the sweep command but don' see the cut part. Sorry guys, I am new to Solidworks. I just ordered Blanchard's book last week. Thanks again.
I have 2"diameter and 20" long tube drawn fo 0.1" thick. I want to make spiral cuts that's only 2" long, 0.125" wide and through the thickness of the pipe. The spiral pitch is 1 revolution over the 20" long. That means that the spiral cut is 36 degrees. I want to make three of cuts that are...