Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
DNV-OS-F101: 2010
As sentenced in DNV,I interpreted the maximum 3mm is allowed any length and over 3mm is classified as excess. Same for "Cap reinforcement(for single sided welds)height given .2t but Max.4mm Thank you so much for your time Shane. Much appreciated Regards.- jssj
- Post #5
- Forum: AWS (welding) Code Issues
-
DNV-OS-F101: 2010
Thank you so much for your quick reply Shane!!! I am not fully convinced though- jssj
- Post #3
- Forum: AWS (welding) Code Issues
-
DNV-OS-F101: 2010
Hi Friends, Help me if you can. I am qualifying welders on a 32 inch 39 thick, "Single V Butt" Gas line pipe and referring acceptance criteria- DNV-OS-F101 2010 for Root penetration "Table-4 Acceptance criteria for visual and surface method testing of welds" "Root penetration (Single side...- jssj
- Thread
- Replies: 4
- Forum: AWS (welding) Code Issues
-
DNV OS F101 Weder Qualification
Dear Friends, It would be much appreciated if any one could answer me on below I am qualified on a 6inch 12mm thick cs X65 pipe 5G GMAW semi automatic machine Down Hill What would be the range of my qualification approved Minimum and maximum thickness and diameter Thanks- jssj
- Thread
- Replies: 0
- Forum: Mechanical engineering general discussion
-
-
NACE MR0175
Dear friends, Please help. In the above subject,what is "M R" stands for? Thanks in advance- jssj
- Thread
- Replies: 2
- Forum: Paint/coatings engineering
