A simple vertical plastic 1/4" rod at point of I.R. beam.
Difference of ambient-to-water point will be obviously magnified. I.R. receiver will show density signal. Taa-Daa.
(Where's my dollar ?)
Non-invasive, 5-minute fix, Radio Shack 'n back ...
A simple vertical plastic 1/4" rod at point of I.R. beam.
Difference of ambient-to-water point will be obviously magnified. I.R. receiver will show density signal. Taa-Daa.
(Where's my dollar ?)
Non-invasive, 5-minute fix, Radio Shack 'n back !!!!!!!!
Spontaneous Cu flash ? Sounds like you are eating Cu line, check for tracks, floor leaks, or wait for the juice to stop flowing in 'that'' circuit. KKRRrrriiiizzzzzzzz......
Negotiator
Exxpansion/contraction will degrade your protection in a handful of cycles. Electroplate with copper (easy), and if
you want corrosion-stop, electroplate over with nickel.
NOW that is cycle-tolerant !!
Make a housing (stainless) to insert a carbon rod into the
flame. These are used to 'cut' steel and when joined with hydrogen and the ambient oxygen in the air, well, you can see it for miles. Non-corrosive, clean burn, and looks pretty trippy (do not stare at it).
Nothing less than a welding...
Your bath will have to be sampled over time and see the
valence imbalances that occur in your mix, about 6:11:1 .
This is not possible to isolate the effect of ionization
upon any-one-pipe. Stainless is so trouble-free when you
cannot afford worry.
Corrosion problem # 3,000,000.
What parameters are we working with; multistrand cable,
single strand 10 gage ? 1/2" cable-treated is a half pound a foot and constant submersion allows 17 - 19 months before
compromise from the 12 ton BREAK rating.
If you want smaller gage go...
They will get their zinc for the day (week). I use stainless (medical grade), so the obvious repurcussions do
not occur (chemical-leeching OR legal).
thestocksguy@hotmail.com
To CPCdesigner: Ultimately as the hulls are finished and
flange work is past weldment stage, I have crew sprayers
cover any questionable areas with K200 Metal-Etch Epoxy
primer. This nullifies the 'nobler metal factor' NOW.
I went through the books, 'tried this - tried that, but
now a...
A feed-back circuit will satisfy this. Create a smart-flow
valve to peak at any level, as-well-as a safety circuit.
Audible or visual warnings could be built around a
LM3914 and a 10-LED bar, & a few transducers. R. S. has
all the stuff, and if you need schematics, ASK...
Once bearing is placed into position (depth of penetration)
swage the opening so the ball will never 'fall out'. The
tips of ball-point pens approach this seizure and they are
a quick manufacturing step that I have used. I now get 1%
of net profits from this...
What are your parameters, app., environment, dimensions,
send diagram for load appreciation. There are many outlets for bearings, and 'STAINLESS' is really an ambiguous description; where case-hardened is the ploy for tapered-roller bearings (RC 56-64), stainless must see lighter load
but is...
The ever-reoccuring frost-up. You find a resolution for that and you will be decorated with three bronze stars. I took care of the sweating of toilet tanks one year by plumbing HOT water in the tank. Cold water initiated condensation, so.......
This was a two-fold accomplishment; no more wet...
