Thank you very much. Yes, I agree.
If I may, I’d like to revisit a point. What I am aiming for is not to solve a particular case but to improve the understanding.
I have resolved more than one case with fillet welds, using continuum elements, both fully 3D models and axisymmetric cases...
Yes, thank you. I have seen them.
I insist on this topic because ANNEX 5-A is informative, and in those figures, there is a fillet, but you can also see in the mesh that they have full penetration.
What I am proposing is a case like this: Imagine a T-joint with a fillet weld. Only a fillet weld...
Thank you both very much. If I was able to see the correct link and if I didn't miss anything, I see that it refers to a fatigue analysis and it doesn't look like a fillet weld. Am I right? If so, it moves away from my original concern.
Should I plot an SCL at the throat of a fillet weld for...
Hello everyone,
Here is my question about a topic that raises doubts in my mind according to different opinions that have been given:
For a plastic collapse and a local failure analyses using the Elastic Stress Analysis Method, for a component under ASME VIII, Div. 2, Part 5, 2021, with a fillet...
