I am writing to ask about how to make this kind of picture.
Are they made by 2D rendering software?
I am a sales who want our customer to know our product clearly through these beautiful picture instead of 2D dwg engineering drawing.
Thank you so much.
Using a Clamp Meter ??
If there are three hot wires connect to the motor , I can clamp one of them and read the current and voltage by the multimeter.
Then how to figure out the power?
Or I need to buy the AC CLAMP POWER METER?
How to know the Power Consumption of the pump instantly ?
How to measure it ?
The electricity source is 3 phase and voltage is 220 V.
I want to build the relation graph between the flow rate and Power Consumption of the pump.
Thank you for the reply
It’s simultaneously the same thing !?!?
But it’s just hard to understand practically.
Like this example.
We put a desired goal into the system.
And the sensor detect the output.
Then the sensor give a signal back to amplifier to compare the desired goal and generate a...
Two kinds of metal, ASTM A494 CY5SnBiM Nickel-base Alloy and sus 316, I ask the foundry to cast.
I did the chemical analysis and found ASTM A494 CY5SnBiM Nickel-base Alloy contains 0.004%W
and sus 316 contains 0.3%Cu.
Because it both will be used in food contact so a little bit worried if it is...
Where could find the regulation about permissible chemical composition tolerance for nickel-based alloy ASTM A494 and stainless steel 316?
Because i ask a foundry to cast ASTM A494 nickel based alloy but the product has W 0.004% inside.
And SUS 316 product has Cu 0.3% inside.
Is it okay ??alloy
