Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. A_Alrumaidh

    ANSI/ASME B1.20.1 thread with API 5B

    Hi, I reviewed a material certificate for a pipe nipple with threading to ANSI/ASME B1.20.1 NPT. However, our requirement was threading to API 5B Table 3. Can I accept this deviation? I checked the dimensional requirements of both specifications and found a minor difference in the height of...
  2. A_Alrumaidh

    API 5L PSL 1 Heat Treatment

    I'm reviewing the latest API 5L April 2018. I'm interested to know the heat treatment requirement for PSL 1 Pipe material, but I can't find it anywhere!! I appreciate if someone can guide me to the clause that specifies this requirement.
  3. A_Alrumaidh

    Why measure Hardness in addition to Strength?

    Why do material specifications (ASTM/ASME) limit the maximum Hardness value, and not Yield Strength? I know that steels with high strength -above a certain limit- indicate a microstructure that is more susceptible to cracking. So why not represent microstructure by Yield Strength? Both hardness...
  4. A_Alrumaidh

    API 571 Creep Threshold

    In that case, on what basis did API 579-1 specify the temperature thresholds in Table 4.1? Is there a criterion similar to the one written in ASME 2D?
  5. A_Alrumaidh

    API 571 Creep Threshold

    TGS4, I agree with you in that the temperature limits between ASME and API 579 are somewhat similar. In ASME, it clearly states the criteria on which these limits were specified (0.01%/1,000hr or 100,000 minimum rupture life). API 579, assessment level 1, specifies a maximum damage of 25%...
  6. A_Alrumaidh

    API 571 Creep Threshold

    Dear, I was studying the API 571 about damage mechanisms and specifically, Creep & Stress Rupture. One thing that caught my attention was Table 4-3 "Threshold Temperatures for Creep". In this table, different materials are listed with corresponding minimum temperatures at which creep becomes a...

Part and Inventory Search