Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. allenbarb

    Adding straight lenght to entry port in Cabling

    Thanks for the advice. We are just now learning ProE/CREO at my company so I have been tasked to learning as many aspects to CREO. So many more questions to come! My past experience has been with SolidWorks.
  2. allenbarb

    Adding straight lenght to entry port in Cabling

    They can be since I am just starting the wiring assembly. So I can constrain the connectors to the external shrink wrap? Then route the wires to the connectors?
  3. allenbarb

    Adding straight lenght to entry port in Cabling

    I wanted to make the wiring as one piece. What I ended up doing was adding a datum point 10mm from the CSYS I created and then adding it as a location in the wire route. It seemed to work! One other general question I have is, for those of you who use this application in CREO how do you set...
  4. allenbarb

    Adding straight lenght to entry port in Cabling

    I have been able to route a number of harnesses in the Creo 2.0 Cabling application but I can not figure out how to maintain a certain straight length to each end of the harness. In other words, I need a minimum of 10mm straight length leaving each connector. Can anyone point me in the right...

Part and Inventory Search