Search results for query: *

If you're using a standard API hub then you can purchase the clamp. If you look at our website we can help with the clamp. Petrotrim Services, LLC www.petrotrim.com

Are you using a standard API hub? Petrotrim Services, LLC www.petrotrim.com

All the requirements are in API-6A/Q1 Petrotrim Services, LLC www.petrotrim.com

Hello A needle choke shouldn't be used to shut off the well. Can you share a cut view of the assy? Petrotrim Services, LLC www.petrotrim.com

what are you looking for? Petrotrim Services, LLC www.petrotrim.com

https://whatispiping.com/difference-between-asme-sec-viii-div-1-and-div-2/ Petrotrim Services, LLC www.petrotrim.com https://whatispiping.com/difference-between-asme-sec-viii-div-1-and-div-2/

See API-6A Petrotrim Services, LLC www.petrotrim.com

Are you making a gate valve? if you make a seat or gate from 30k material using 10k PSI the parts wouldn't pass API calculations. Our gate valve uses 75k material for the bonnet, body, flange, etc, and 75k trim or higher for the valve trim. We typically use 410SS 75k for the stem, gate, and body...

The original type m was intended to only seal downstream. The upstream seat pocket has a non-sealing seat assembly which allows pressure to bypass the upstream seat and equalize throughout the valve body and only seal against the downstream seat. The handwheel is used to torque down the gate...

It's a nickel base steel, ALLOY 625, Cast N26625. I would ask the vendor making the spool for MTR's. Petrotrim Services, LLC www.petrotrim.com

What are you making using 316SS / TC? Petrotrim Services, LLC www.petrotrim.com

The correct material strength would come from the results of your calculations on the trim parts. Petrotrim Services, LLC www.petrotrim.com

Hello This is from a Cameron H2 Choke manual. https://res.cloudinary.com/engineering-com/image/upload/v1659563014/tips/manual-Cameron-H2-Choke-1_wkexow.pdfhttps://res.cloudinary.com/engineering-com/image/upload/v1659563022/tips/manual-Cameron-H2-Choke-2_ytsrcd.pdf H2 manual Petrotrim...

are any parts being hydro-tested made from a casting? Petrotrim Services, LLC www.petrotrim.com

We have used 5k equipment for 7,500 psi rated equipment in the past. We hydro tested at 1.5 W.P. I would make sure the hardness test is being done correctly and the tools are calibrated. Petrotrim Services, LLC www.petrotrim.com

What is the yield strength from the MTRs? What type of wellhead equipment? Petrotrim Services, LLC www.petrotrim.com

If you're using API-6A 21st Ed. see 7.5.1.5 Petrotrim Services, LLC www.petrotrim.com

I would start with the dimension shown in API 6A for 20k flanges. From there use math to figure out what requires more material. I've never seen an API 25/30K flange. Petrotrim Services, LLC www.petrotrim.com

Hello We used N/A on all of our PQR/WPS. Petrotrim Services, LLC www.petrotrim.com

API uses 8-3/4"-4 2G for their 6"-1502. I've never seen a 2202 and it's not shown in API 7HU2. Petrotrim Services, LLC www.petrotrim.com