Thanks everyone for your suggestions. We have come across a couple of things since the last time I wrote.
For the capsule, several materials weren't overmolding to themeselves very well (PEEK and LCP mainly) and were either pushing the part through the cap or not sealing off correctly. This...
Hi there,
I have a design problem with sealing out moisture during autoclaving.
We currently are using a ferrite core wrapped in magnet wire with a cap in series to make a rf excitable lcr circuit. When exposed to rf energy this circuit rings at a certain frequency and q factor.
The problem...
I have a NEMA 4X box that needs to have a threaded panel mount sma connector attached to the outside for an external antenna. Do I need to put a NEMA 4X approved gasket underneath this connector, or does the nut and washer constitute an appropriate seal to maintain the NEMA 4x rating?
