fredb -
Once again, Thanks for your response. After I posted my last note I noticed this problem with my equations. I was however assuming around .9 eff motor and we did back out about .84 - .88 power factor at the pumps. But I do have some good news on this situation. About 1 foot or so...
fredb -
Thank You for responding and helping me out! I guess I was just confused on the equations you gave me b/c I was using some I found in my old thermo book that are as follows:
Wpump,shaft = Wpump,u / eff(pump) = rho*V*g*h(pump,u) / eff(pump)
and
Welect = Wpump,u /...
Hello all: I am new to this forum. I am no pump expert and am just beginning a project involving nothing but pumps. I have so many questions and would greatly appreciate some good advice. I am trying to figure out what our pumps in the cold well are actually putting out (GPM). Sounds easy...
Could somebody tell me where I can find the final resistance value an earth electrode should reach? Former BS where stating it, but now is everything confusing...
The sites I have to protect are Telecom's RBS (small antennae sites) power supplies, and there is a lot of confusion regarding the...
