Dear Skogsgurra,
Thank you for the offer. I checked that software out and it seemed legit, nonetheless I have to do this simulation with Maxwell, maybe next time I'll give that a try.
sincerely
Dear aussiejohn2,
thank you for your opinion.
I thought so at first but to examine that I defined a transient BH loop plot to see what happens inside the hard magnetic material as the simulation was being conducted, it appeared that it does not make such an assumption and simply goes up and...
Dear aussiejohn2,
I'm afraid so, the hysteresis motor works on the principle that in hard magnetic matters the area enclosed by the loop is considerable so the energy conserved in the loop could be used to produce acceptable torque so it's imperative that in fact it should be a loop not a...
Dear Skogsgurra,
Thank you for you quick response.
Unfortunately, there does not seem to be an apparent way of defining a BH loop as the case for BH curve. Yes there is a look up table and I have tried it but when I enter the values for the whole loop, an error pops up which can be seen below...
I am trying to simulate an electric motor in ansys maxwell software, but I can't define the whole loop in four quadrants for the material used in the rotor however it is essential to do this since the motor is of hysteresis type and works on the principle of working point moving all around the...
Hello,
I'm trying to simulate a 3 phase hysteresis motor with 4 poles, 36 slots, input voltage peak 220 for each phase, 50Hz, specified dimensions and 0.6 N.m output torque in maxwell transient.
The magnetic material used is LNG52 which is also known as alnico600, alnico5DG(ACA52) and alcomax...
