I´m not sure if I understood the difference between "slips when torque reaches a maximum" and "transmits torque, up to a maximum"....after reaching a maximum won't it start slipping...and so, aren't they the same?
Do you, with your experience in Magnetic coupling, think its applicable to...
Does anybody has experience in specifing, instaling Magnetic Coupling? The usual problems and misunderstandings. For example: I'll use it for conveyor belt drives. 200 CV X 1180 rpm. It must limit the torque to 140% of the maximum. Is it possible? Can't it miss its magnetig properties in case of...
Hello,
I'm with a problem: I have a 150 [CV] ; 440 V drive. But unfortunaly the available power supply for this is a bit far, and there is to much tension loss during the starting of this equipment (a conveyor belt), higher then our customer would aprove, requiring an huge investment in...
Hello,
I'm with a problem: I have a 150 [CV] ; 440 V drive. But unfortunaly the available power supply for this is a bit far, and there is to much tension loss during the starting of this equipment (a conveyor belt), higher then our customer would aprove, requiring an huge investment in...
Does anybody has already have experience on assembling two load cells, side by side, expecting to have a new one, with two times the capacity of each one? Doesn't it inflict in loss in accuracy or in problems during instalation?
I'm collecting information to project a 3,850.00 tons silo...
