israelkk;
I came across with some related literature about low carbon steel grades 1008,1010,1018 and 1020 and yes, they have good magnetic properties too. So I have also gone browsing the internet hoping I can find a supplier in my country for these steel grades but to no avail, I haven't...
Remetaper;
Here are my answers to your question.
1) Its not mandatory that i will use 15-5ph or 440c. it just so happen that they are the available scrap materials i have right now so i was just thinking if how i can make use of them.
2) Yes,I want to buy high performance magnet steel alloys...
Remetaper,
I am looking for any steel which has magnetic permeability of around 3000 to 150 at saturation. Magnetic flux density saturation level should be at around 17 kilogauss at around 100 Oe magnetizing force.That is of course making use of magnet steel alloys like Ni-Fe, Silicon-iron...
i was reading the technical paper on soft magnetic properties of 15-5 ph and i realized that the magnetic permeability for this alloy is way down low, existing at around 50 to 180....something only. With this range in values of magnetic permeability, I dont think it would be practical to use it...
remataper;
Thanks for your very kind reply. I appreciate it. I tried to check the forum last april 9, 2009 under the headings of metal and metallurgic eng forum but i can't find a relevant topic to my concern, instead I have seen something about 17-4ph topic last April 30,2009 under the same...
I am currently working on DC motor design and i am confronted with the problem of unavailability of magnetic steel in my country for my design, I'm from the Philippines. I tried contacting cartech but they said my order is too small for them. But i have available stainless steel in my backyard...
