Hi guys,
I would like to enquire on the limitations and criterias to meet in order to use adaptive meshing in ANSYS, as well as the steps to use adaptive meshing in ANSYS both in the GUI and command methods.
I am trying to use adaptive meshing on this geometry below:
/Prep7
! Define Geometry...
Hi DanJordy,
Can you tell me how will I be able to plot out the inital input of the forces? In order to verify that the input is a half-sine curve? ( GUI or Batch commands? )
Thankx for your time..I be trying that string you supplied and will feedback soon.
Hi
I was wondering if this will work for the input of force in a half sine wave..Can anyone help me check for errors?
*DEL,_FNCNAME
*DEL,_FNCMTID
*DEL,_FNC_C1
*DEL,_FNC_C2
*DEL,_FNCCSYS
*SET,_FNCNAME,'example'
*DIM,_FNC_C1,,1
*DIM,_FNC_C2,,1
*SET,_FNC_C1(1),100
*SET,_FNC_C2(1),50...
Hi Doug n Brian,
Firstly, thanks for the replies. I am trying to apply a sinusoidal force to simulate a vibration at the end of a beam. I was told it was suppose to be a transient analysis as the response is not to be harmonic. Thus, I strong believe is a mode-superposition transient analysis...
Hi could anyone tell me where can I find very clear instructions of sine input of force via array commands? or is there an alternative to this?
Thanks alot for reading this :)
Regards,
Dunstan
Sorry guys, I type wrongly some things. Let me rephase myself again.
I am encountering a problem with choosing my input in this situtation. Simulating a harddisk dropping on the ground.
My questions are:
1) Should this be a transient or harmonic analysis? As I understand the input load is a...
Hi guys,
I am encountering a problem with choosing my input in this situtation. Simulating a harddisk dropping on the ground, having an acceleration as an inital input.
My questions are:
1) Should this be a transient or harmonic analysis? As I understand the input acceleration and load...
