Thanks for your replies. I find now though that in order to get the mates I need, I need to generate a revolved section to set the angle at precisely 28.09 degrees. The lofted sheet is much more difficult to get this angle. So I have the full cone and I perform an extruded cut through both...
being new to SolidWorks I think my problem is very minor but I thought I'd post it here. Have tried both a revolve and a loft with no success in creating a cone and then the flat pattern for it.
I create an arc on a plane. Then I create a plane the distance away from the first plane the...
I have a question for katmar based on a response to a question on air receiver sizing. The below response was in response to a sizing question and I have an acquaintance that is referencing an adiabatic index of air which I did not see in your response. Can you or anyone tell me why or why not...
