Hi all,
I am confused in quadratic mean of acceleration signals. I have seen one report where quadratic mean graph is provided for 12 acceleration signals in frequency domain and I have been asked to do the same. All these acceleration sensors have mounted on one big gear box and quadratic mean...
Hello,
I want to design a sandwich construction (of length 65mm) which will be bolted in two flanges by using long studs. Application will be in steam service up to 20 bar pressure and sizes will be 1 inch to 4 inch in diameter. The said sandwich construction will not have flanges and will have...
Dear All,
A simple question but always I ger confusion with this.
If I given a tolarance on shaft Dia. 10 -0.030 & hole Dia. 10 +0.050/+0.030 then the machinist will make the job at higer tolerence of hole and lesser of shaft?
Yash
