Thanks for the information, but I am unable to send the model. (not my choice). I was thinking about dividing the faces using: > insert > divide > face? The only problem is, at the top of the fin, there is a radius, I'm not sure how to make a curve there to have a boundary to use for the divide...
I have more than one problem with the model. When I try to grab the top of the fin to just make a mill operation for the top, part of the top half as well as bottom half highlight, as you can see in the jpeg.
I can't pick an edge to define a curve or boundary at the top because the model doesn't...
I just started using NX4 and have a problem using a model for making a program. I have a part that is an impeller. It is sitting down on a table with the blades fanning out horizontally, (they are swept) and the hub axis vertical. I am trying to use "fixed_contour" operation to rough the blades...
I just started using NX4 and have a problem using a model for making a program. I have a part that is an impeller. It is sitting down on a table with the blades fanning out horizontally, (they are swept) and the hub axis vertical. I am trying to use "fixed_contour" operation to rough the blades...
