When I try to use the symetric offset when doing a cutout I have issues selecting the lines I want to offset. When I go to select the line I want to offset a line in the middle of the screen apears and I can't select the line I want. I'm not sure if I'm explaining this very well but it's...
When I return to the assembly enviroment from editing a part the information in my edge bar doesn't come back. It's docked on the side but the feild is gray and none of the information updates. I have to shut it off and turn it back on to get the information back. Anyone seen this issue...
When I make a draft file of an assembly it seams that everything I do with it is very slow. Even just flipping over to an assembly window from the draft and the other way around. I've defraged, that helped some. I got ride of all the v16 folders, that helped some also. Any other ideas?
I have a sand point with a pump located at my hunting cabin. I'm looking at using a tankless hot water system for an outdoor shower. The pump has just a pipe coming out of the ground with a switch to turn it on and off so their is no holding tank. If I connect a hose directly from the pump to...
I'm having difficulty using the framework function. I can't get my frame members to be generated on the correct side of the sketched line. Is there any rule as to where the frame member will be generated.
I have a 4 four button mouse (five including roller) and I want to set up the thumb button to initiate the zoom window comand. I've set up my key board to have a CTL W initiate that comand but I can't figure out how to do the same with the mouse. I know you have to do some changes in the...
