Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. ZattleBone

    Is there life after yield...

    Mmm, thanks for the responses guys. I think I should explain in a little more detail though. I have a wire 2mm thick and I want to compress it across it's thickness by 0.5mm (i.e. 25%). I then want to completely remove the load (allowing it to recover approx 20 microns) then reapply the same...
  2. ZattleBone

    Is there life after yield...

    Hi there I have a particular application where the compression of my part induces stresses WAY beyond the yield stress. The small amount of elasticity remaining in the part is fundamental to the design as it has to survive approx one million cycles of +/- 20 microns. Unfortunately on the...
  3. ZattleBone

    Workstation advice...(uk)

    Hi I'm looking for a new workstation for running NLFEA with MSC.MARC Processors: Dual P4 Xeon 2.4Ghz (or better) Memory: 1Gb (2x512Mb) HD: 18Gb SCSI (or equiv) Graphics: NVIDIA Quadro4 900 (or equiv) No monitor Cost: £3000 Can anyone suggest any uk...
  4. ZattleBone

    Rubber FEA

    If you "serious" about modelling rubber, MARC and ABAQUS and you only real choices. Both packages allow you to do pretty much anything you want, however each has its own unique set of strengths and weaknesses. If your unfortunate you may find your decision restricted by financial...

Part and Inventory Search

Back
Top