Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Champkkc

    What does D,ALL, UY,PI/4 after CSYS,1 do ??

    I have a question regarding boundary condition in cylindrical coordinate system. CASE: If I have selected a node and applied the following boundary condition. CSYS,1 NSEL,S,NODE,,1 D,ALL,UY,PI/4 NROTAT,ALL CSYS,0 Does the node rotate 45 degrees along the circle ? I have searched a lot for...
  2. Champkkc

    Boundary conditions to rotate a single element by 90 degrees

    Hi, I am having trouble having a simple verification test done in ansys. I am trying to rotate a single element (PLANE182) by 90 degrees expecting a zero stress. But, there is some stress developed both in x and y direction because volume is not being conserved while rotating. I presume this...
  3. Champkkc

    Importing Matrix of mixed types into Matlab

    Try this [t,x,y,z] = textread('temp.txt','%f %f %f %f' ,'headerlines',23);
  4. Champkkc

    How to rotate the geometry in ANSYS

    Hello Everyone, I am trying to work out an example illustrating importance of frame indifference in constitutive modeling. To do that, I have a created a rectangular plate under uniaxial tension in the global coordinate system. Now I need to rotate this initial configuration by some angle...

Part and Inventory Search

Back
Top Bottom