Search results for query: *

I think I can do it. Although im not sure how to do it. Im using Hypermesh & NX simulation as my model panel. Can you advice me on how to do it? Thanks in advance. :)

Can anyone give any feedbacks? Highly appreciated!!

Hi all, I'm trying to calculate the torque on a shaft. I have a plate that is attatched to a shaft. Im applying pressure on the plate and trying to calculate torque using abaqus. I have used cylindrical coundaries on the shaft to fix it on the axial rotation (Theta). Any ideas on how I should...

Thank you everyone for the suggestions :)

Any ideas?

I just used the average shear force. But I only considered one cross section area, because one of the links makes the force there. I have found the bending stresses, but I still don't get the matching answer I need. The 12600N is the ultimate load. So when using the chain it is not suitable to...

Yes..

Can someone check the image and let me know your opinion? Thank you!

Thank you everyone for the help. racookpe1978 : The 5 links are oval shaped. I have attached the sketch below. The FEM analysis working fine. I used 1mm elements with tie contacts. But the hand calculations are confusing comparing to the FEM results. Normal stress is correct in FEM and in hand...

Can someone help me please?

Hi, This is my first post here. I have read a lot of the threads and learned so much. I have problem calculating shear stress on a chain link i hope someone can help me. The chain link is consisting with 5 links that is 10mm in diameter. I found the normal stress and compared it with my FEM...