Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Borrowing problem
Hi, I have borrowing problem. When I borrow license form server it works just fine and when I disconnect from server drafting application slows down(modeling works fine). When I connect with server again it works like it should. I described it few months ago but then I didn't know cause...- AndresR
- Thread
- Replies: 0
- Forum: Siemens: UG/NX
-
Drafting problem
Hi, I have working with UG about 3-4 years and I have third computer which is faster than previous. So it's not a problem. Also this problem comes and goes. Two minutus is long time when making simple drawing takes about 2-5 minutes, and if you have to wait after every step 2 minutes (adding...- AndresR
- Post #4
- Forum: Siemens: UG/NX
-
Drafting problem
Hi, I have a problem with drafting. Sometimes adding view in sheet takes long time (30 sek to 2 min) and sometimes after click 1 second and view is in place. I can't figure out from what it depends. In modeling speed is always good without any problems. In old computer I had the same problem...- AndresR
- Thread
- Replies: 4
- Forum: Siemens: UG/NX
