Plugging
Plugging is a method of motor braking in which the motor connections are reversed so that the motor develops a counter torque which acts as
a braking force.The counter torque is accomplished by reversing the motor with the reversed motor torque opposing the foward inertia torque of...
Jbartos,Thank you once again for your insight.
I will check out and save the link.
To try to share some info with you,I think might be hard to do.I have found out it is always gigo.Plc
and programs do not make mistakes.May have glitch,
may get corrupt or just get lost.we run four
auto lines...
Did more reading in a few books Plugging is
full power in reverse....My Boss Is wrong...
There I said it now I will give a defition without using the words full power to get a raise...Father in law
said bow down get the raise I feel like telling him he and the boos are wrong ..
Right is right...
Jbartos,Thanks for the reply, I need a better
Definition than swap two phases to 3 phase motor
for plug breaking this is for a paper to give to boss
for a $2/hr raise...I looked in my study book of mtr/ctrls.
And it is explained switch two phase to put mtr in reverse and bring it to a quick...
I used switch two phase to quick bring motor to a stop.
Boss said voltage is reduce also???
This last question and definition is the
deference of 2/hr,,
I have adjusted cards but believe that is soft stop.
I believe plug breaking is full voltage pulse to motor
from switch phase to make motor...
