Another option is to enter whatever text you want int the "Text override" field. Click on whatever dimension you want to modify and find the field under the "Text" heading. Whatever you enter in here will override the dimension measurement. If you want to still use the measurement value just...
thread794-158690
Regarding the above referenced thread from 2006, and addressing BSME3 and arto if they are still active forum-goers. Does anyone have the calculations for Section VIII Div 1 Appendix 13 in an excel spreadsheet format? My company uses Computer Engineering Inc's DesignCalcs for...
Another question regarding the setup explained above:
The first weld we do is of the 4140 rod to the A36 plate, and we can stress relieve this weld joint after the weld is done. The last weld we do is another piece of A36 to these 4140 rods. I've found that when this weldment is done, the...
I have an 8" Dia x 24" long rod of 4140 annealed steel which I am welding to a 1" thick plate of A36. The plate will be midway up the rod, so 12" from the end. I'm only welding on one side of the plate as the other side is inaccessible (inside a pipe). My question is two fold:
1) When I...
We are trying to silver solder 660 Bronze to 1020/1018 steel. My welder tried using Safety-Silv #56 rod at first, but we got pitting in the weld, particularly on the steel side of the weld bead.
We want to try using Safety-Silv #45T in our next trial, since the company claims it is designed for...
racookpe,
Thank you for recommending this option. The part is currently made of solid bronze. We are investigating options to minimize cost of material. The idea of shrink fitting a bronze "sleeve" into the cylinder has already been eliminated by the end customer for their reasons (cannot...
A little background: I have a cylinder approx 14.5" inside diameter by 7.5 inches long. Wall thickness is yet to be determined. I'm investigating problems that may arise when building up an aluminum bronze overlay on the inside of this mild steel cylinder. I'm looking at Crown's Royal ALB-30...
Jordan,
j is the jacket inside radius minus the shell outside radius. These are shown in the Fig. 9-5 sketches as Rj and Rs respectively.
1) S is the max allowable stress per Sec. II part D for the jacket material.
2) I'm assuming tj and ts are the nominal thicknesses without the corrosion...
Can I use bar made of SA-276-304 as an equivilant to SA-479-304 in a pressure vessel? The code heading for the material spec does not list it "for Pressure Vessels" and the code software I use (Computer Engineering Inc.'s Advanced Pressure Vessel) does not have it listed as a possibility. Any...