Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. DanDwig

    Small Water-Water Temperature Control

    That is our fallback position, but I was hoping there might be a solution with one system instead of two separate ones. Water-Water units are certainly capable of the precision and power required, so I don't see a reason not to switch if one is available.
  2. DanDwig

    Hollow Shafting

    You've probably considered this, but can you find anything with a stock ID in the range you need and just turn down the outside? It's a bit of an odd size I admit, but it looks like something with a 2 1/8" ID would be pretty close.
  3. DanDwig

    Small Water-Water Temperature Control

    I am currently working on a system that uses two small (400 w www.customchill.com CRAL400R) thermoelectric rack-mount chillers to control the temperature of two independent water baths. We are getting some negative feedback from the customer on the heat output of our system, and need to...
  4. DanDwig

    mapkey selection

    Michael, Thaks, this did the trick. Of course I'm still fighting about three other things where pro doesn't behave consistently, but at least I can do the plane selection. Dan
  5. DanDwig

    mapkey selection

    I am attempting to creat assorted life simplifying mapkeys. In order to get the best use out of them, I need to be able to use them in parts created with several different templates. These different templates have setup datum planes that are named the same, but apparently have different node...
  6. DanDwig

    Suppresing Components with Relations

    Thanks, that did the trick. I'm just getting into the advanced assembly stuff. Dan
  7. DanDwig

    Suppresing Components with Relations

    I am attempting to make a fully parametric assembly using relations. The primary variation in the assembly is length. At lengths above 25" a certain component is present, at or below 25" it is not. Is there anyway to use relations to turn this component on or off? I would prefer not to use...
  8. DanDwig

    Inexpensive, 10BaseT slip ring

    BALLUFF electronics has a remote device that passes signals inductively, and it should be cheaper than a multi component slip ring. I don't know a whole lot about it, I haven't had cause to use one yet but you might want to check it out.
  9. DanDwig

    automated parking garages

    The one near D.C. is located in the terminal parking garage at BWI (Baltimore Washington International). At this point it is a limited installation. As I understand it it uses a sensor, type unknown, to determine the presence of a car in each space. If there are open spaces iluminated arrows...

Part and Inventory Search

Back
Top