Search results for query: *

Ok ;) unfortunately the sketch was not very good generated. So here againhttp://files.engineering.com/getfile.aspx?folder=29b577da-e304-4ba8-9ed3-d3c3288e3d6d&file=sketch.jpg

Hey Guys, I am trying to figure out the best design for a new test bench and stuck with a interesting question. I try to analyse the resulting heat flow of a cylindrical specimen (bearing) with a diameter of about 90 mm. This bearing has in the load zone a higher heat dissipation than in the...

Greetings, Marko

Hey IRStuff, Thank you very much for your fast and helpful response. You're right that I would be more sensefull to share the worksheet so I translated it in english for a better understanding and attached it on the response. Well your second advice is that my construct of blending...

Hey Guys, i've an interesting question for you! :) I'm currently designing a test bench with a focus on heat transfer of bearings. Therefore I've studied this topic and want to calculate following example: A horizontal cylinder out of steel is heat insulated on the fronts (so that no heat...

Hello together, I'm simulation a forming process in Abaqus Explicit. To avoid element distortion I used Ale adaptive meshing. Well now i did a DOE and it showed, that a higher Ale-frequency results in a higher forming force. Well if the frequency is higher, the elements are less distorted and...

Hey guys and girls, i've some problem that i'm working on: I've an explicit forming simulation and i want to use a butterworth filter to have a good force-displacement-curve. To find out the best cut-off frequency of my butterworth-filter i found this in the abaqus manual: "If you perform a...

Hey imagine one block of steel(let's say the upper one) sliding on another under high pressure. The upper one starts to slide and the contact area increases. Now my problem is that during the sliding process the resulting friction coefficient changes because of a decrease of lubrication and a...

Hi, I'm trying to simulate a assembly process with a steel on steel contact. The problem is, that the lubrication is decreasing during assembly, and so the friction is way-dependent. Is there any way to modell this? I've tried to use partitions on one of the two contacting partners, but because...