I am intrested in the maximum tension who acts on the plate, since it is made of plastic, so the joint r going to be dimensioned after the plate and not the rivet, the durability of the rivet wont be a problem, but i need to find the von mise for the plate, so to speak.
Best regards
Konsulten
If a rivet is subject to a force of let us say 900 Newton, how would i calculate the maximum tension which act on the plate.
I don't think i can do it with F/A since the tension shouldn't be evenly distributed since the hole is circular.
Sorry about my english
kindly Konsulten
If you have hot air staking with glasfiber reinforced PET plastic against steel. Do you guys think it will be a problem with the termal expansion, if the temperature will raise up to 140 degree celcius, since the plastic will be glued to the steel sheet, which should create a shear force?
The...
Are there any formulas to calculate the Mating Force with friction when the part has an angle as shown in the picture below.
http://img147.imageshack.us/img147/8291/snapfitangelwh2.jpg
I haven't found any formulas which takes a angel like that in to consideration
Any answers are appriciated!
When you have friction between two surfaces, then u use the relative friction coefficient right. But how do i do that with ansys? I have put contact element between two different materials, but it doesn’t seems as I can use the relative friction in ansys instead i have to write an friction...