Thanks jvian!!!
I managed to apply the pressure load by using the surface option.
Yes, you are right about the bug there. One can ignore as you say.... but I have noticed that with these unwanted simulation volumes in the model, the computation time increases somewhat.
Hi, a Pro/mechanica newbie here. So bear with me:).
I have a long cylinder. I want to apply a pressure load in the internal surface. But I want to apply the load to only half of the internal surface.
I know I should be using the "simulation surface region" or a "simulation volume region"...
Thanks for the reply TED!
The system is exactly the same in all aspects except for the place where the flow is being measured.
It is not possible for me to provide a schematic right now.But I will try to explain the setup a bit more in detail.
First of all it is an open circuit (as opposed to...
Hi,
I have a test setup where I measure the flow rate of hydraulic oil at high pressure (before a pressure relief valve). The pressure ranges from 100-350 bar. On another test setup this flow is measured at the low pressure side (i.e after the pressure relief valve).
The data from these two...