Good to know thanks I assumed that was the other possibility haha. It's been years since I did any real engineering calculations(obviously). Luckily I did find a lot of my old engineering textbooks from when I was in ME to reference but I figure a lot of this specific motorsports info is not...
The reason there is discussion on motion ratio though is to achieve acceptable amount of travel correct?
I assume you want to avoid a situation where you say only have half the motion of the wheel translated to the suspension otherwise you need twice the spring rate/damping ability?
thanks for...
Thanks WolfHR, that is actually like a design I was thinking of(on the Pagani but obviously not exactly like that).
In terms of the terminology I still don't understand how the setup on the Zonda would be a pull rod setup. Unless in this situation the control arm is technically the "pushrod"...
Hey Everyone,
So I have tried to do some searching but haven't come up with concrete information. My only current book is Chassis Engineering by Herb Adams which is no help in this question.
I wanted to ask people with first hand knowledge of this. I am looking to build an AWD tube chassis...
