Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Open Channel Flow and headloss in bends
Well usually in treatment plants the flow velocities in the open channels are slow enough and the total length of the open channels are short enough the headloss accumulated in theses channels can be safely ignored, considering you will be conservative everywhere else. If you have a baffled...- FrankHW
- Post #2
- Forum: Waste disposal & treatment
-
Fairbanks Turbo-Free Suction Elbow
Will have one installed on a 400 hp vertical non-clog pump soon. Interested to see other people's experience with it as well. Op, what makes you think the noise / cavitation is caused by the Turbo-Free elbow?- FrankHW
- Post #2
- Forum: Civil/Environmental engineering general discussion
-
Recommendation for Job Site Cameras
Hey guys, my office is considering purchasing a job site camera for time-lapse project recording. I have very little knowledge about these cameras and after some research online I see there is wide pricing range from a bit above a hundred dollars to several grand. Can someone give me an...- FrankHW
- Thread
- Replies: 13
- Forum: Civil/Environmental engineering general discussion
