Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. emily126

    Resistivity of Si

    7.8e-8 T(Ohm)(um)= 7.8 ohm-cm?
  2. emily126

    Resistivity of Si

    7.8e-8 T(Ohm)(um)= 7.8 ohm-cm?
  3. emily126

    RESISTIVITY of Si

    7.8e-8 T(Ohm)(um)= 7.8 ohm-cm?
  4. emily126

    RESISTIVITY of Si

    Hi~ Once I found that resistivity of p-type Si is 7.8e-8 T??m, is it equal to 7.8?cm?
  5. emily126

    Resistivity of Si

    Hi all~ Once I found that resistivity of p-type Si is 7.8e-8 T??m, is it equal to 7.8?cm?
  6. emily126

    Resistivity of Si

    Hi all~ Once I found that resistivity of p-type Si is 7.8e-8 T??m, is it equal to 7.8?cm?
  7. emily126

    Piezoresistive Analysis of pressure sensor

    If I take the nonlinearity factor into account, does any change in the formula above?
  8. emily126

    Piezoresistive Analysis of Pressure Sensor

    Hi all~ I am doing a piezoresistive analysis of Pressure Sensor. A square diaphragm (3000?m x 3000?m x 50?m) with 4 resistors above is in interest.The pressure is applied perpendicular to the diaphragm. The resistors are collected in Wheatstone bridge so that the 4 resistors are aligned in...
  9. emily126

    Piezoresistive Analysis of pressure sensor

    Thanks for your suggestion! Do you have a formula for square diaphragm?
  10. emily126

    Piezoresistive Pressure Sensor

    hi~ I am doing a piezoresistive pressure sensor with 4 resistors above the diaphragm so that a Wheatstone bridge is formed. As I'm only beginner in ANSYS, this job is quite hard to me. I have several questions to ask, I'll be grateful if you can help me. (1) I would like to compare the...
  11. emily126

    Piezoresistive Analysis of pressure sensor

    HI all~ I am doing a piezoresistive pressure sensor with 4 resistors above the diaphragm so that a Wheatstone bridge is formed. As I'm only beginner in ANSYS, this job is quite hard to me. I have several questions to ask, I'll be grateful if you can help me. (1) I would like to compare the...
Back
Top