Hi,
I need to create a toolpath to cut a chamfer on my part. I have tried using the curve following but the tool tip always follows the edge causing the tool to gouge the chamfer. Therefore I will need to either specify a curve that is offsetted from the chamfer edge or to specify an offset...
It works!!
As you pointed out, the key is to click on "apply" after creating parameters in properties interface or to select okay and then open the properties interface again.
Then by right clicking on the parameter value, the option "edit formula" appear and lets you link...
Hello Akesson,
I tried the procedure that you outlined and could not follow it completely.
I can add parameters in the part properties but it does not allow you to
create a formula. It appears that any parameters added to the part properties
are independent from the parameters created in the...
