Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. sam413

    igs flat pattern to .dxf format

    Thanks to everybody for all the great tips. In the end our solution was to switch to a software that didn't exhibit the symptoms that Fabriwin had. Tebis proved to be a much more forgiving software for processing not only the laser programs but all cnc programs. Thanks again Sam
  2. sam413

    igs flat pattern to .dxf format

    Derek, The software I use prefers .dxf format. I can get the native Catia drawing file but in the past it hasn't helped much. In the past I have "fixed" the gaps between lines and arcs with my programming software but this can be time consuming be cause of the nature and amount of...
  3. sam413

    igs flat pattern to .dxf format

    Derek, Thank you so much for the tip. Maybe you can help me with a similar issue. I'm a CNC programmer and dont use Catia for anything other than file conversions. The problem I have been having is with .dxf models I receive from my customer that were made in Catia. When i read then into my...
  4. sam413

    igs flat pattern to .dxf format

    I'm searching for a procedure in Catia v5 to output a .dxf file from a .igs. Basically the .igs is a flat pattern laser template that I need to save as .dxf so i can process it through a laser programming software. Any help or advice would be greatly appreciated. Sam
  5. sam413

    catiav5 .igs to .dxf

    I'm an inexperienced user of Catia v5. I'm looking for the procedure of exporting a .dxf file from an .igs flat pattern. I know there is a way to convert a 3d model into a 2d flat pattern but I dont have the knowledge or time to figure it out. Any help would be greatly appreciated
Back
Top