Hello,
I'm struggling with this thing:
Documentation says:
"The mapping definition can be set by the administrator.
In this case it can also be locked."
I managed to enter admin mode, however this setting to unlock keywords is nowhere to be found.
Would be grateful for any tips here. Thank you!
Thank you Tomas!
Now, by "the alignment between start and end section" do you mean the sketch orientation mismatch?
(as a similar issue described in this thread: http://www.eng-tips.com/viewthread.cfm?qid=349853 )
Hello, I've run into a problem using Swept command (shown in the attached file).
I need to sweep a constant circle section along a guide until the end of the second ark and then continue until the end of the guide resulting in the conical shape after the second ark. However, I get a non-linear...
