Thank you BigInch.
Now, if I consider a pressure of 1100psi for saturated steam, this corresponds to a temperature of 556 F. If I intend to use ANSI 600, entering the table based on my temperature, I would have these values
T1= 500 F, P1= 1200 psig and
T2= 600 F, P2= 1095 psig).
Should just...
Yes I'm new at this. Most of what I know is what I learned in school (Mec Eng).
Regarding all the variables, I have 3 pipe sizes, 2 schedules, one material, 2 heights H (available from manufacurer) and a conservative estimate of extenuating circumstances.
I intend to run models with different...
I am modeling an expension loop for steam distribution lines. What are the most fundamental steps that I need to take in order to complete a table of standard dimensions?
I have a Caesar II model that I intend to resize to generate different case scenarios and create a table. However, I'm not...