mfgenggear,
I've been told that the imbalance will be measured using an in-house balancing machine though I'm unaware of how they are going to set it up correctly.
It has been assumed that a single correction plane will be used as there is only one area by which to add or remove material...
Timoose,
I have used 6.3 for my preliminary calculations though the part is actually a welded assembly and has 6 gears within so is a far cry from a "machined all over part".
The thing I was not sure about is that it is supported by a drive shaft at one end which isnt "rigid" (it is...
Hi guys,
I'm having some trouble getting my head around how to balance the rear carrier in an AT.
I have this standard:
ISO 1940 - Mechanical vibration -- Balance quality requirements for rotors in a constant (rigid) state -- Part 1: Specification and verification of balance tolerances
Is...
engjeff,
Were you able to find a way to have every sheet in the external drawing documents update automatically once they were instantiated?
I am currently facing the same problem and have so far only been able to have 2 of the 4 drawing sheets update automatically.
I am not sure where to...
