Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. InFlames

    lifting/tailing calculation

    Arash, Try third edition, chapter seven deals with erection of pressure vessels, you will found it there. Sorry about no having mentioned edition before ;) "Non-flammable" is not a challenge
  2. InFlames

    lifting/tailing calculation

    Hi! Almost all calculations I have seen are based on Pressure Vessel Design Manual by Denis Moss. If you can manage to get a copy a simple method is shown for calculating loads during erection on lifting/tailing lugs and for sizing welds, pin holes, etc. "Non-flammable" is not a challenge
  3. InFlames

    Minimum Required Thickness of Cone at Small End

    Hi to everyone! I'm almost new designing with ASME VIII but If you pick up Pressure Vessel Design Manual you will find a procedure ( 4-2) in wich is evaluated your problem. The required thickness either for internal or external pressure is the required thickness of a shell under internal or...
Back
Top