We are getting constant 926 FSSB Alarm on an LC 3015 F1NT laser. When it happens, all the buttons on the control go blank and are unresponsive. It drops out the high voltage and requires a hard shutdown. Suspect maybe the COP7 optical fiber cable that runs from NC controller to HSSB Board in...
Hello, we have a new to us LC3015 F1NT, it is a 2008 model. When we got it installed and I was getting the software setup, I could load a sheet on the shuttle table while cutting and press "Work Set Ready". I have M707 at the end of our programs, so if the button is pressed the machine will...
Our Laser had to have the controller power supply swapped out. When we powered on after, it needed a B-axis zero. We started going through the procedure but we have an alarm light and the message "2164 EZ CUT". I can not find any reference to this message in any of our manuals or anywhere...
No solution yet. Suspect it is a cable issue, but we are still looking into it. Had a guy here for service on the machine and could not get it to happen while he was here, of course it happen 2 hours after he left. I will check the rack, but i believe that has already been checked. It only...
Hello, I have an Amada LC-3015D2 with the C2000B laser that we are having issues with. The machine shuts down and drops high voltage almost every time it passes X5.30 going towards X0.0. When it started we were getting a "2158 Shutter Enable Key" alarm and the machine had to be fully shut...
