Hi,
I am involved in fishing boat refrigeration units and I have a doubt. If some of you could help me in this it will be great!
The design requirement is to cool two compartments at two different temperatures to be controlled independently.
The two compartments and the temperatures are...
Hi,
I am in need of support from an expert in the field of dipping painting for continuous production of metal pieces for the above mentioned design project.
I have been asked to design a dipping line for coating Chemlok 205 primer for a production process in our factory.
the primer is to be...
i am looking for a welding technique that can be applied for online joining of steel wire ropes. i am looking for a welding or soldering technique which will give rise to a sufficiently strength joint. the ropes are arround 4mm in diameter and having app. 40 small wires twisted in bunches(the...
I am working on a design project of air to air heat transfer requirement where the heat is generated by diesel fired funace at a temperature arround 900 oC. and the load at the clod side to be maintained at app. 200 oC.
I selected the plate type heat exchanger because it is said to be highly...
The HE will be a plate one where both hot side and cold side folws will pass through number of slots each of square section 1.5mm * 600mm at both hot and cold sides. lenght of these flow paths are app. 1.5m. that is why the expansion is critical.
Hi all,
I require the composition of diesel smoke produced at the diesel combustion in steam boilers.
I only requir the average values of composition based on the volume of the basic gases that exist in the diesel smoke.
for example;
CO......... % by volume
CO2.........% by vloume
N2..... and...
Hi all,
I am looking for some help on the ways of fabricating plate heat exchangers such that they remain undeformed at higher working temperatures than normal out door conditions; for example a common material used for HE is SS316H grade. this has a thremal expansion coefficient app. 17*10^-6...
I am having a design issue where a Plate heat exchanger to be designed and fabricated for the following requirements.
* heat transfer takes plate from hot diesel burnt flue gas(700 oC)to normal air(200 oC) both media is at 1 bar pressure.
* heat load is app. 70 kW
* flow rates in the flue...