Dear Greg,
thanks a lot for your support!
Unfortunately, the simulation with PIPE mode takes for ever and hasnt finsihed over the weekend.
I stopped it, since its not practical to run it for multiple days.
I was looking into the interpolation settings and communication intervals between...
Hi Greg,
I'm using ADAMS View.
I just found out why there was no msg/req/res file created.
I was using the interprocess option "DIRECT" instead of "PIPE".
Here, the creation of these files is turned off to speed up the simulation as I've learned from the ADAMS controls plant documentation.
I...
Hi Greg,
unfortunately, also these files are not there.
Is it possible to check the file path ADAMS uses to store these files?
I couldn't find anything in the settings of my model or in the controls plant export dialogue, neither in the .adm, .cmd or .m file.
Thanks,
Sebastian
Hi Greg,
thanks for the hint!
Apparently, ADAMS didn't create a msg-file.
Is there a toggle I have missed where you can switch on and off the msg-file creation?
I checked in the controls plant export and also in the Simulink block, but I couldn't find anything.
I also checked another cosim...
Dear all,
I've encountered an issue when running my co-simulation between ADAMS and MATLAB Simulink.
The simulation runs without any issues for 100s. After 100s ADAMS stops updating my state variables.
Consequently, my closed loop controller saturates at the control variable limit. The...
