Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. charif

    overclosure too severe

    Dear all, I am launching a simulation of a pipe whch by expansion hits a wall. the wall is placed at 9m of the pipe in the Y-direction. to simulate the contact, I created a new entity (the wall) and i gives to my wall propriety of a contact. *CONTACT PAIR,INTERACTION=WALL PIPESURF_WALL,WALL...
  2. charif

    save and write output files between steps

    is it enough to juste include *WRITE as this *INCLUDE,INPUT=operating_cycle_Temp8.inp *WRITE *INCLUDE,INPUT=operating_cycle_Temp9.inp *WRITE *INCLUDE,INPUT=operating_cycle_Temp10.inp *WRITE *INCLUDE,INPUT=operating_cycle_Temp11.inp *WRITE *INCLUDE,INPUT=operating_cycle_Temp12.inp
  3. charif

    save and write output files between steps

    Dear all, I am launching a fatigue analysis with several operating and shut down cycles. and I wish sawve output files after some steps.the aim is to restart from this outputfiles a transient analysis. if you need more information, I'm available thanks in advance
  4. charif

    codes to restart a simulation from previous results

    Dear all, I am starting on abaqus and this question can seem obvious but I was wondering if It's possible to start a calculation from previous results on ABAQUS. By the way, I am trying to simulate the deformation of a pipe under several pressure and temperature profiles, as I am not sure of...
Back
Top